Sentry US ACSK-EM Manuel d'utilisateur télécharger pdf (Page 5)

MOUNTING INSTALLATION

Note: Before mounting, decide first where to mount the keypad.

1. Open the control keypad by removing the screw at the bottom using the provided

torque wrench.

2. Push the front cover up a few millimeters and then lift the lower edge (no more than 20

degrees and remove the front cover gently.

2. Punch the necessary holes at the back template for the screws.

3. Using the back template as a guide, drill the holes for the screws and system wiring

(make a bigger hole for the system wiring).

Note: Level the back template

4. Draw out the system wiring through the center hole of the back template.

5. Mount the back template using the screws provided.

6. Mount the front panel using the torque wrench.

7. Connect system wiring (see System Wiring Diagram and System Wiring Connections).

1 2 3 4 5 6 7 8 9 10 ... 13 14

Pas de commentaire

Sentry US ACSK-EM Manuel d'utilisateur Page 5